Diy: Seahorse Resin Pendant!
This post was operate of Resin Crafts Blog in May.
ETI-Resin sent me all this amazing resin for this sponsored post.
All the ideas, opinions together with craziness are my own.
DIY: Seahorse Resin Pendant!
I similar creepy jewelry. I e'er purchase something novel some Halloween fourth dimension to wearable out.
Like fangs, bats, or spiders. I dear spider jewelry.
What's better...a DIY for a creepy novel necklace!
This adorable seahorse pendant is awesome...but mightiness survive a piddling disturbing to some folks. We dear jewelry that makes a statement. If cute seahorse bodies isn't your thing, think almost other fun things you lot tin embed inward resin to brand stunning jewelry.
I similar creepy jewelry. I e'er purchase something novel some Halloween fourth dimension to wearable out.
Like fangs, bats, or spiders. I dear spider jewelry.
What's better...a DIY for a creepy novel necklace!
These seahorses are similar to these beetle necklaces I made a pair years ago.
We similar these creepy pieces for their wow factor.
So let's beak almost the seahorse or hippocampus.
Seahorses are pop inward Asia for eating, infusing inward liquor together with teas.
So...this necklace feels a piddling less disturbing.
You volition need:
Seahorses, ocean stars, beetles, or other fun detail to embed inward resin
I got a dozen seahorses on Etsy.
They are a piddling creepy, non going to lie.
Read the resin together with hardener directions carefully earlier beginning.
Make certain you lot accept everything laid out together with develop earlier mixing the resin.
I mixed upward a bunch of resin because I was doing multiple projects at the same time.
You solely remove plenty resin to fill upward up one-half of the desired molds.
Fill them almost 1/8 to 1/4 inch amount together with allow them laid a pair hours.
Then laid the seahorses correct on plough over of the resin.
If it sinks to the bottom...pull it out gently together with expression a piddling longer.
You wishing it to sit down correct on plough over of that layer of resin.
Then mix upward a piddling to a greater extent than resin together with fill upward the molds alongside the resin.
I should accept used a dropper, but I only poured it.
It's slowly to construct clean upward afterward it's done.
Let them harden for a few days.
Pop them out of the molds together with allow them sit down out some other 24-hour interval or so.
Next, exercise a minor drill fleck together with add together a minor hole at the plough over unopen to the edge.
Use caution together with thus you lot don't drill through the edge.
Now they are develop to add together to necklaces.
I used some wire together with wrapped a loop on the top.
Then I used some velvet ribbon for the perfect choker.
Hook it to the ribbon alongside a jump ring!
Add the clasp to the ends of the ribbon together with it's develop to wear!
Or add together a jump telephone together with chain for a much simpler necklace!
I dear that see shaped pendant!
I finished each ane off differently together with I dear them all!
Which ane is your favorite?
Would you lot ever wearable a Seahorse necklace?
Would you lot ever brand one?
Cool or Creepy?
Like, Save, Pin, Follow, Comment together with Share!
